Building materials
Wood/Wood composites
  Beams, columns, lintels
Particle composites
Fibre composites
Planed wood
Wood flooring and parquet
Lining materials
Foils/Barriers/ membranes
Façade solutions
Further information
  Explanation of Data sheets - support information

Data sheet (pdf, 88KB)

print version

    fibre composite - Hardboard

Hardboard consists of lignocellulosic fibre (e.g. wood, straw, bagasse) of thickness of up to 8 mm and a density of > 900 kg/m. Hardboard is manufactured using heat and pressure. Most hardboards are produced in a "wet process", where a fibre moisture content of more than 20 % at the forming stage is common. In these hardboards, one face is rough due to the use of a mesh screen for dewatering. Boards manufactured in the "dry process" exhibit smooth surfaces on both sides. The panels are bonded primarily by felting of the fibres and their inherent adhesive properties. Usually, only small amounts of a synthetic binder are added to the fibres. By incorporating additives (e.g. hydrophobic agents, fungicides, fire retardants) or post-treatments certain properties of the board can be altered. Due to their visco-elastic behaviour boards can be shaped during processing, and bends with a radius of as little as 25 cm are possible.
  Details of sustainability rating (Basis: tdry mass)

Hardboard 900 kg/m

[kg CO2 Äqv.]
[kg SO2 Äqv.]
PEI ne
[kg PO4 Äqv.]
[kg C2H4 Äqv.]
359,6 -1.700,0 1,9 12.777,8 27.222,2 0,6 0,2

Manufacterer according to EN 622-2
Product Manufacturer
FunderMax Biofaser FunderMax GmbH DoP/techn. Information (pdf, 1315KB)